028 TESTING SKEINFORGE SUPPORT SETTINGS
Printed Thing:337423. Used default Durbie profile with Skeinforge. Made these changes: Initiated support at 50 degrees. Set Base layers at 0 from 1. Set Interface Infill density (ratio) at 0.25 from 0.5. Set Interface layers to 2 from 0. Set Support Flow Rate over operating flow rate (ratio) to 0.8 from 1.0. Printed well with good removable support for this model.
Print time: [02:11:13] Total Service Hours: [29:01:37]
No comments:
Post a Comment