007 TESTING THE Z AXIS

This test is to check the Z zxis for problems.  It’s using the 20mm calibration cube extended to 458mm (18″). Skeinforge slices with 3.0mm ABS filament.

The print was successful, but with some issues.

There is wobble in the Z axis after 80mm or so.

The temp was lowered from 200 degrees C. to 185 C.  after ~60mm due to wall distortion

The print is straight and there isn’t warping or delamination from shrinkage.

Print time: [5:09:00]   Total Service Hours: [10:19:58]