099 TESTING SLIC3R FLOW PROFILE

3mm Orange ABS filament. Sliced with Slic3r  1.2.9 using as close approximation to Skeinforge default settings (Durbie Normal) with these changes: Filament Dimension set to 0.9. Cooling set to Minimum Cooling Speed 2.0 sec. retraction values are set at Slic3r default. Infill is changed to Line pattern. Checked Infill Only Where Needed. Print temperature 215 degrees c.! The intention has been to keep extruder temperature and filament dimension equal with all slicers. This may not be possible.

Print time: [00:21:52]   Total Service Hours: [57:12:19]