098 TESTING SLIC3R FLOW PROFILE
3mm Orange ABS filament. Sliced with Slic3r 1.2.9 using as close approximation to Skeinforge default settings (Durbie Normal) with these changes: retraction values are set to Retractraction Length: 6.0mm and Speed: 100.0 mm/s. Infill is changed to Line pattern at 15%. Checked Infill Only Where Needed. Changed Cooling Minimum Print Speed to 2 sec. Changed Maximum Print Speed in Autospeed to 32 sec. Changed Extrusion Width to to 75%. Print temperature 230 degrees c.
Print time: [00:24:37] Total Service Hours: [56:50:27]
No comments:
Post a Comment